Miele CS 1012-1 G Manual de Instalação descarregar pdf (Página 19)

The burner does not ignite after several attempts.

Possible fault Solution

Disconnect the appliance from the electrical supply for a few seconds. If the

problem persists, check if:

– The burner is assembled incorrectly.

– The gas valve is closed.

– The burner is wet and soiled.

– The flame slits are dry and

unblocked

– Reassemble the burner as shown in

"Cleaning and Care - Burners".

– Open the gas valve.

– Clean the burners. See "Cleaning

and Care".

– Dry the igniters.

The flame goes out after being lit.

Possible fault Solution

The flames are not touching the ignition safety control. Check if:

– The burner is assembled incorrectly.

– There is no soiling on the ignition

safety control.

– Reassemble the burner as shown in

"Cleaning and Care - Burners".

– See "Cleaning and Care".

The flame appears different than usual.

Possible fault Solution

The burner is assembled incorrectly. Reassemble the burner as shown in

"Cleaning and Care - Burners".

The flame goes out during operation.

Possible fault Solution

The burner is assembled incorrectly. Reassemble the burner as shown in

"Cleaning and Care - Burners".

Frequently asked questions

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 43 44

Sem comentários

Miele CS 1012-1 G Manual de Instalação Página 19