Miele KM2354 Manual descarregar pdf (Página 38)

Preparing the worktop

Make the worktop cut-out following

the dimensions applicable.

Remember to maintain a minimum

safety distance from the back wall,

as well as from any tall unit or side

wall to the right or left of the hob. See

"Safety instructions for installation".

Seal the cut surfaces with a suitable

heat-resistant sealant to avoid

swelling caused by moisture.

If, during installation, you find that the

seals on the corners of the frame are

not flush with the worktop surface,

the corner radius (ß R4) can be

carefully scribed to fit.

Installing the hob

Feed the connection cable down

through the cut-out.

Place the hob in the cut-out without

securing it.

Connect the hob to the mains (see

"Electrical connection").

Connect the appliance to the gas

supply (see "Gas connection").

^ Secure the appliance using the

brackets a supplied.

Installation

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 51 52

Sem comentários

Miele KM2354 Manual Página 38