Miele CS 1122 Manual do Utilizador descarregar pdf (Página 28)

General

Fit wall units and extractor hood

before fitting the hob to avoid

damaging the surface.

The veneer or laminate coatings of

worktops (or adjacent kitchen units)

must be treated with 100 °C

heat-resistant adhesive which will not

dissolve or distort.

Any backmoulds must be of

heat-resistant material.

This equipment is not designed for

maritime use or for use in mobile

installations such as caravans, aircraft

etc. However it may be suitable for

such usage subject to a risk

assessment of the installation being

carried out by a suitably qualified

engineer.

The hob may only be built in over a

Miele oven if the worktop is at least 40

mm thick.

After the hob has been installed,

ensure that the connection cable is

without hindrance and that there is no

mechanical obstruction which could

damage it, such as a drawer.

These appliances must not be

installed over a dishwasher, washing

machine, tumble dryer, refrigerator or

freezer. The high temperatures radiated

by hobs could damage the appliance

below.

Spray canisters, aerosols and other

inflammable substances should not be

stored in a drawer under the hob.

Cutlery inserts must be heat-resistant.

All dimensions in this instruction booklet

are given in mm.

Safety instructions for installation

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 47 48

Sem comentários

Miele CS 1122 Manual do Utilizador Página 28