Miele KM 2334 Instruções de Operação

Operating and installation instructionsGas cooktopsTo avoid the risk of accidents or damage to the appliance it is essentialto read these instructions

Safety with children~Children should be supervised toensure that they do not play with theappliance.~Older children may use theappliance only when its

~The connection to the gas supplymust be carried out by a suitablyqualified and competent person inaccordance with current local andnational safety re

~Do not connect the appliance to themains electricity supply by amulti-socket unit or an extension lead.These do not guarantee the requiredsafety of t

~For added protection, it is advisableto use heat-resistant pot holders orgloves when using the appliance.Ensure that they do not come intocontact wit

~Using the cooktop creates heat,moisture and products of combustionwithin the room in which it is located. Itis important to make sure the room issuff

Disposal of the packingmaterialThe transport and protective packinghas been selected from materialswhich are environmentally friendly fordisposal and

Please place the extra data plate on a surface near thecooktop such as the cupboard door if the labels on the baseof the cooktop are not visible after

The control knob for each burner is used to ignite the burnerand regulate the strength of the flame.The burners can only be switched on by pressing in

Control knobsThe control knob for each burner is used to ignite the burnerand regulate the strength of the flame.ß The gas supply is turned off& S

Regulating the flameRegulate the flame so that it does not spread out beyond thesides of the pan. As the outer part of the flame is much hotterthan th

WO This appliance can be used in countries other than those specified onthe appliance. It is, however, set up for connection to the gas and electricit

Burner Min. pot/pan base diameter in cmSmall burnerMedium burnerLarge burnerWok burner10101215Max. diameter at top of pot/pan in cmwithout withCombi i

Wok ringThe wok ring supplied with your appliance can be used ininstances where extra stability is required. It is particularlysuitable for woks with

–Use a lid whenever possible to minimise heat loss.–Cook with as little water as possible.–Cooking times can be significantly reduced with apressure c

Thermo-electric ignitionThis appliance is fitted with a thermo-electric ignition safetydevice which cuts off the supply of gas to a burner if theflame

,Do not use a steam cleaning appliance to clean thisappliance. The steam could reach the electricalcomponents and cause a short circuit.–The appliance

Cleaning NotesStainless steelsurfacesClean stainless steel surfaces using anOriginal Miele all purpose microfibre cloth orwith a solution of warm wate

To assemble the small, medium and large burners^ Place burner head b onto burner base e so that theignitor d and the ignition safety device c extend t

To assemble the wok burner^ Place burner head c onto burner base d so that theignitor f and the ignition safety device e extend throughtheir respectiv

With the aid of the following guide, minor problems can be diagnosed and easilycorrected without contacting Miele. Please note that a call-out charge

Problem Possible cause RemedyThe gas flame goes outafter being lit.The flames aren't touching theignition safety device andtherefore it is not he

Description of the appliance...5KM 2312...5KM 2334...

Miele offers a comprehensive range of useful accessories aswell as cleaning and conditioning products for your Mieleappliances.These can be ordered on

This appliance must be installedand connected to services byauthorised personnel to therequirements of AS 5601, wiringrules, local and national author

Safety clearance above the cooktopA minimum safety clearance must bemaintained between the cooktop andthe rangehood above it. See therangehood manufac

Side / rear clearances to the cooktopIdeally the cooktop should be installedwith plenty of space on either side.There may be a wall at the rear and at

Before installing the appliance, checkthat the location provides the requiredclearances from combustible materialand, if necessary, provide protection

KM 2312a Frontb Building-in depthc Gas connection R 1/2 - ISO 7-1 (DIN EN 10226)d Mains connection box with mains connection cable, L = 2000 mmBuildin

KM 2334a Frontb Building-in depthc Gas connection R 1/2 - ISO 7-1 (DIN EN 10226)d Mains connection box with mains connection cable, L = 2000 mmBuildin

Distances from burner to the edge of the cooktopKM 2312KM 2334Building-in dimensions37

^Make the worktop cut-out for thecooktop in accordance with thebuilding-in diagram. Remember tomaintain a minimum safety distance(see "Safety ins

SealantThe sealing strip under the edge of thetop part of the cooktop provides asufficient seal for the worktop.Do not use sealant between theframe of

Building-in dimensions ...35KM 2312...35Distances from

Secure the appliance as shown, usingthe fixings supplied.20 mm worktop30 mm worktop40 mm worktopAfter installationIgnite all the burners to check that

All electrical work should be carriedout by a suitably qualified andcompetent person in strictaccordance with the wiring rulesand national and local s

Connection to the gas supply, orconversion from one type of gas toanother should only be undertakenby an approved gas fitter, who isresponsible for co

The gas connection must be inaccordance with the requirements ofAS 5601 and national and localregulations.The relevant building regulationsmust also b

Nominal ratingsKM 2312Burner Gas type Highest setting Lowest settingMJ/h MJ/hSmall burner NGULPG4.03.41.10.6Large burner NGULPG9.88.31.72.3Wok burner

,Connection to the gas supply, or conversion from onetype of gas to another, should only be undertaken by anapproved and registered gas installer in s

Changing the jetsDisconnect the gas cooktop fromthe electricity supply by switchingoff at the socket and withdrawingthe plug or by disconnecting thema

Wok burner^ Remove the burner cap ab andburner head c.^Using an M7 socket spanner,unscrew the main jet d.^Fit the correct jets securely (see jettable)

Changing the small jetsTo change the jets, the burner fixing screws must first beloosened and the upper section of the appliance removed.^Pull the con

Checking operationCheck all gas fittings for leaks.^Reassemble the appliance.^Ignite all the burners to check that they are operatingcorrectly.The fla

KM 2312a Wok burnerb Large burnerc Small burnerd Pan support (2 parts)Controls knobs for the cooking zones:e Leftf Rear rightg Front rightDescription

In the event of any faults which you cannot remedy yourself, please contact Miele.The contact details for Miele are given at the back of these instruc

51

M.-Nr. 09 703 600 / 01en-AUKM 2312 / KM 2334

KM 2334a Small burnerb Medium burnerc Wok burnerd Medium burnere Medium burnerf Pan support (3 parts)Controls knobs for the cooking zones:g Front left

BurnerWok burnera Outer burner capb Inner burner capc Burner headd Burner basee Ignition safety devicef IgnitorSmall, medium and large burnersa Burner

Accessories suppliedThe accessories supplied with your appliance, as well as arange of optional ones, are available to order from Miele (see"Opti

This appliance complies with allrelevant local and national safetyrequirements. Inappropriate usecan, however, lead to personalinjury and damage to pr