Miele KM 2256 Manual do Utilizador descarregar pdf (Página 34)

Making the worktop cut-out and

building in the hob

Make the worktop cut-out following

the dimensions applicable.

Remember to maintain a minimum

safety distance from the back wall,

as well as from any tall unit or side

wall to the right or left of the hob.

See "Safety instructions for

installation".

Seal the cut surfaces with a suitable

heat-resistant sealant to avoid

swelling caused by moisture.

If, during installation, you find that the

seals on the corners of the frame are

not flush with the worktop surface,

the corner radius (ß R4) can be

carefully scribed to fit.

Feed the connection cable down

through the cut-out.

Place the hob in the cut-out without

securing it.

Connect the hob to the mains (see

"Electrical connection").

Connect the appliance to the gas

supply (see "Gas connection").

Secure the appliance at the back and

front using the fixings supplied. See

"Securing the appliance".

Installation

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 55 56

Sem comentários

Miele KM 2256 Manual do Utilizador Página 34